Tesenso Industrial Edge

Product Datasheet

Datenblatt DE

Tesenso Industrial Edge Gateway Datenblatt.pdf

PDF · 668KB

Open

Datasheet EN

Tesenso Industrial Edge Gateway Datasheet_EN.pdf

PDF · 818KB

Open

Login to your Device

Your Tesenso Industial Edge is normaly in the DHCP mode. You can type the IP on the Display (=Device IP) into your browser

EG: 10.147.19.183:1880

Important: After the IP add the Port! xxx.xxx.xxx.xxx:1880

Mainscreen / Tesenso Industrial Edge

Controlls / Settings

1. UPDATE DEVICES: Updates the status of your M-Bus Devices

2. SCAN: Make a scan of all M-Bus devices

3. RESTART: Make a restart of the M-Bus Controller (in case of problems)

4. CLEAR SELECTED: Warning: Deselecting all active M-Bus Devices

5. ADD SECONDARY ADDRESS: Allows you to add a M-Bus device, which was not found with the Scan

6. REMOVE SECONDARY ADDRESS: Allows you to remove a M-Bus device, which was automatically or manually added.

Initial Setup

During commissioning, the first step is to make a scan. Alternatively, the M-Bus devices can also be added via secondary address. Press Button 2

Scan in Progress

Scan completed: Two M-Bus Devices found

Check the Result of the scanned M-Bus Devices

Click Button 1 - to Update the status of the Devices

Result_ Two Energy Meters: 1x Elictricity and 1x Gas - Meter

Check the Payload of the M-Bus device by clicking on the Secondary Address

Payload Gas Meter

Payload Electricity Meter

Activate the M-Bus Devices to send the data into the Tesenso Cloud

After the payload control, the M-Bus devices still have to be selected- so that the data can be transmitted to the Tesenso Cloud. To do this, simply activate the checkbox. The data will be forwarded instantly.

Troubleshooting / FAQ

1. M-Bus Device is not visible after a scan

   Solution 1: Start the scan again, sometimes it takes several attempts Solution 2: Add the M-Bus device manually: Enter the complete Secondary Adress in the field and press ADD SECONDARY ADRESS, then UPDATE DEVICES. The device should now be displayed and the payload can be read. Solution3: Check the connection / wires from your M-Bus device